What are the common problems of tents

1, Q: The tent pole is bent, what is the way to straighten it?
A: Block one end of the bent rod, and then fill the yarn from the other end into the inside, fill the pile solid, and then block the mouth, in the bend (V or U) gently use a wooden hammer (stick) to beat, not part of the pipe to fill the sand, repeat the above steps until the knock straight, the force should be light. The wind strength of the rod after being knocked straight is reduced, and a slightly thicker pipe can be found here to increase the strength. If the rubber band is connected to trouble during operation, you can remove it and then perform the above operation.
Usually, an aluminum or iron pipe should be placed on the most stressed part of the pole to increase the strength.
If it is fiberglass, blow it straight with a hot hair dryer or go to the upper study outdoor Club for a bar, 5 yuan.
2. Q: Why do you want to fill sand?
A: The purpose of adding sand to the inside is to prevent the aluminum tube from deflating and producing dead bending, and the steel bar of the bicycle is also a way to increase the strength of the aluminum tube under stress.
3. Tent packing problem
Perhaps some people for the tent packaging is a small matter, in fact, it involves the interaction between the equipment manufacturer and the user.
If you often look at some outdoor activities outside the tape, you carefully pay attention to their tents are in the backpack, not as we generally hang outside the backpack, if you are using foreign tents, you will find that the biggest difference between them and domestic tents is that the camp post and the tent is separately packaged, folded tent cloth, its volume size in line with the diameter of the backpack, So that the tent cloth can be placed in the backpack, and the camp column is inserted on both sides of the backpack, which is a foreign designer, considering the concept of the user, the previous frame type of aluminum frame backpack, camp packaging problem is not big, but today's mainstream frame type of straight backpack, it is difficult to carry the domestic design of tent packaging, it is not impossible to change, only you give up the original manufacturer designed to consumers frame, Naturally, it can also be very comfortable.
The average person's approach is to discard the original tent coat, use the sleeping bag cover or sleeping bag waterproof cover to install the inside and outside the tent, so the tent will not appear outside the backpack, so long walk or walk in the intermediate mountain is more than the tent length far wide backpack trouble, think of carrying the tent will be hung vertically in the backpack, the appearance of tying meat dumplings, placed across the backpack, and afraid of hitting the trunk or falling wood.